Sunplus Loader Tool Updated !!exclusive!!

Most modern Sunplus receivers use a 3.5mm jack to RS232 female cable, while older models use a standard DB9 female-to-female cross cable.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Open the Sunplus Loader on your PC, select the correct COM port, and load your firmware file. Initiate Flash sunplus loader tool updated

Windows 7, 10, and 11 (requires proper Prolific/FTDI drivers for USB adapters)

Select the correct matching your Device Manager settings. Most modern Sunplus receivers use a 3

Reviving boxes stuck on "Boot," a red light, or a blank screen after a failed Wi-Fi or USB update.

: When a receiver fails to boot due to a bad update or power failure, the loader can force-install a fresh "dump" file to restore functionality. If you share with third parties, their policies apply

Once the transfer hits 100%, the tool will automatically start the process. Do not touch the cables or close the app.