Manual Best — Autoclave Tomy Sx700
is critical for safe and effective operation. Below are the key steps to operating the device based on manufacturer guidance. 1. Pre-Operation Setup
Comprehensive Guide to the TOMY SX-700 Autoclave: Features, Operations, and Best Manual Practices
| Frequency | Action | Instructions | | :--- | :--- | :--- | | | Check water level | Refill reservoir with distilled water. | | Weekly | Clean the door gasket | Wipe with a soft, damp cloth; check for cracks. | | Monthly | Clean the strainer | Remove and clean the water intake filter inside the chamber. | | Every 50 cycles | Descaling | Run a "Clean" cycle with Tomy descaling agent (or citric acid). | | Every 6 months | Replace air filter | Located behind the front panel. | autoclave tomy sx700 manual best
Utilize the optional external temperature sensor to monitor the actual temperature of the articles being sterilized. This is especially important for liquids. Utilize the Printer Option
Check if the chamber water is too cold at start-up, or inspect the heating element for severe scale buildup minimizing heat transfer. 6. Safety Precautions is critical for safe and effective operation
| Feature | SX-700 (57L) | SX-500 (36L) | | :--- | :--- | :--- | | | 325 mm | 225 mm | | Heater Power | 2.0 kW | 1.5 kW | | Critical Manual Difference | Cooling coil wiring diagram | No cooling option |
220V/230V/240V AC, Single Phase, 50/60Hz (Requires a dedicated grounding line). Pre-Operation Setup Comprehensive Guide to the TOMY SX-700
Slide the locking lever to the engaged position. The unit features a dual-interlock system; it will not start unless the lid is completely sealed and locked. Step 3: Selecting the Program Turn on the power switch.
She sat down, flipping through the pages with practiced speed. The paper rattled as she moved past the safety warnings— Warning: Risk of Explosion —and skipped the basic setup instructions. She found the troubleshooting index.
The system detects an open or short circuit in the main temperature sensor. Turn off the unit, wait 10 minutes, and restart. If it persists, the sensor requires professional calibration or replacement.